DIY Gold Napkin Rings
This project is a inexpensive way to fancy up your place settings on a budget!
Materials Needed
20 Gauge Copper Wire, Baking Roller and Wire Cutters.
You can get a little thicker wire if you wish.
Step 1
You are going to start by wrapping the wire around the rolling pin.
Make sure you leave about a inch to a inch and a half at the end that is not being wrapped.
Step 2
You are going to wrap the wire around the rolling pin 10 times.
Then using the wire cutters, cut the wire leaving a inch to a inch and a half left over at the end.
Step 3
With the extra ends, you want to twist once.
Step 4
Now carefully remove the wire. Hold the wire together tight do to the fact we have not tide the wire together. If not then it will all come apart.
Step 5
With the ends wrap the extra wire around the ring.
Step 5 Continue
Make sure you wrap each side of the extra wire going the opposite way. For example, the right wire, push it forward around the ring. The left wire, pull it back around the ring.
Step 5 Continue
Continue to wrap the ends till you have just a little bit left.
Step 6
Now with what little of the wire is left twist the ends.
Step 7
Then twist the reminder around the ring leaving nothing else sticking up.
Step 7
All Done!
Lastly separate the wire.
Thank you for reading! I hope you enjoyed this DIY Home Decor
More Thanksgiving Table Decor Ideas
Resources for this project:
Comments
Join the conversation
-
I have enjoyed this project. Very pretty.
-
Very elegant 🌷
Frequently asked questions
Have a question about this project?
Where is gold ? In the beginning it says gold. It's pretty as copper!